Simple Head & Tail + Engine Idle Sound
ITEM#: LEDMFUV5SEI-22
This kit has wires pre-attached to the 4 small LEDs, a speaker, a button and a 50mA Rechargeable
battery already. This kit comes completely soldered and ready to be installed.
For custom sound. Please send me an email first.
Modes includes:
Car alarm will chirp twice and lights will flash when button is first pressed
1. OFF
2. Low beam with tail lights
3. High beam with tail lights
4. Lights will flash 3 times and Engine will start and idle
6. Engine cuts off and everything turns off
If car is not played for 3 minutes. It will arm itself with a chirp and go to sleep mode.
Speakers and sizes:
Please type in the notes which one you'd like. Default installed is the small rectangle version.
- Used for 1/64 Scale due to it's size. - Used for larger scale for louder sound
- Default speaker used
Small Speaker 9x16mm Rectangle Larger Speaker 27mm Round
Just drill your holes, make your lense and glue the pre-attached LEDs to your chasis.
Drill a hole on the base and glue the push button and the charger connector and you are set.
You can also drill your speaker hole on the base and glue it facing down for clearance.
Note: Careful not to glue the push button stick.
Only apply a dab of glue to the corners initially.
Add head lights and tail lights to
your 1:64 car or larger scaled cars. No programming skills needed.
No power toggle switch needed due to battery saving smart Chip design.
Kit includes:
1 x LEDMFUV5SEI PCB pre-wired to LEDs
2 x WHITE LED (Head Lights) attached
2 x RED LED (Tail Lights) attached
1 x Speaker attached - Small Rectangular or Medium 27mm Round (Please specify in the Notes)
1 x Button attached
1 x Lithium Battery 50mA attatched
1 x JST 1mm Connector attached (Charger Port)
Caution: DO NOT Short the (+) and the (-) of the Lithium Battery together.
Video: