FULL Automotive LED Controller Kit (DIY)
ITEM #: LEDMFUV5DIYKIT-23
Installation Manual is available for Download.
Add real functional lights to
your 1:64 cars or larger scaled cars. No programming skills needed.
These are all the components you need to setup your die cast cars to have realistic, full functional
lighting, that is controllable with just three fingers. The way you naturally hold your die cast car, you
won't even notice the difference with our Patent Pending setup and features.
Except you have full functioning lights.
Kit includes:
Includes everything for a FULL build.
1 x LEDMFUV5 PCB
9 x WHITE LED with Leads Pre-installed (0603)
2 x RED LED with Leads Pre-installed (0603)
4 x ORANGE LED with Leads Pre-installed (0603)
3 x Push Buttons
1 x Speaker DO NOT Remove pre-installed masking tape.
It's used to muffle the sound so it's not so high.
1 x Red 0.2mm Enamel wire - Used for connecting everything together (60" long)
1 x Green 0.2mm Enamel wire - Used for connecting everything together (60" long)
1 x Connector Female - Used to connect to battery charger
1 x Connector Male - Used to connect the + and - in the car, so it can be charged. Mount at bottom of car.
1 x 3.7V 50mA Battery - Very small battery to put inside of the car.
1 x
3.7V Battery Charger board. (You need to install the female connector that comes with the kit)
All chips are fully tested before shipping.
Firmware v1.2
installed.
Installation Manual is available for Download.
NOTE: Don't forget to add more LEDs or Buttons to your cart.
Just in case you damage any LED during the process. :-)
Note: Battery must be charged with a 3.7V Lithium Ion charger device only.
Caution: DO NOT Short the (+) and the (-) of the Lithium Battery together.
Note: If you selected to have functions disabled. You DO NOT need to hook up the LED for that function.
Video: