This kit has wires pre-attached to the 14 small LEDs, a button and a 50mA Rechargeable
battery already. This kit comes completely soldered and ready to be installed.

This kit has Head Lights, Tail Lights and Underglow lights. Requires rechargeable PCB is you don't have one already.

Modes includes:   

                             1. OFF
                             2. Low Beam and Tail Lights
                             3. High Beam and Tail Lights
                             4. Low Beam and Tail Lights ON while Underglow slowly fades on and stays on
                             5. Low Beam and Tail Lights ON while Underglow fades slowly on and off

 

Just drill your holes under your car, fill it with clear glue and glue the pre-attached LEDs to your base
Drill a hole on the base and hotglue the push button and you are set.
Or glue the button under the windshield and cut the windshields to it pushes on it for top level actuation.

Note:            Careful not to glue the push button stick.
                     Only apply a dab of glue to the corners initially.
                     We suggest hot glue for this part.

Functions are easily controlled with a push button.
No power toggle switch needed due to battery saving smart Chip design.


Kit includes:

1 x LEDMFUV5UG PCB
14 x LED attached
1 x Button attached
1 x 3.7V 50mA rechargeable battery attached
1 x JST Male charger port attached

Caution:    DO NOT Short the (+) and the (-) of the Lithium Battery together.

VIDEO: