This kit has wires pre-attached to the 8 small LEDs, a button and a 50mA Rechargeable
battery already. This is for a Police Simple Kit with Siren setup with 2x pair of red/blues LED strobes only..

Modes includes:   

                             1. OFF
                             2. Low beam with tail lights
                             3. High beam with tail lights
                             4. Red/Blue strobes wig wag
                             5. Police chase mode with siren

 

Speakers and sizes:

Please type in the notes which one you'd like. Default installed is the small rectangle version.

- Used for 1/64 Scale due to it's size.                                - Used for larger scale for louder sound
- Default speaker used

                                                          

Small Speaker 9x16mm Rectangle                                   Larger Speaker 27mm Round

Just drill your holes, make your lense and glue the pre-attached LEDs to your chasis.
Drill a hole on the base and glue the push button and the charger connector and you are set.

Note:            Careful not to glue the push button stick.
                     Only apply a dab of glue to the corners initially.

Add head lights and tail lights to your 1:64 car or larger scaled cars. No programming skills needed.
This kit comes completely soldered and ready to be installed.

DON'T FORGET to buy the kit with the Charger Kit if you don't have one already.

Functions are easily controlled with a push button.
No power toggle switch needed due to battery saving smart Chip design.


Kit includes:

1 x LEDMFUV5PFS0 PCB
2 x WHITE LED (Head Lights) attached
2 x RED LED (Tail Lights) attached
2 x RED/BLUE pairs of flashers
1 x Button attached
1 x Lithium Battery 50mA attatched
1 x JST 1mm Connector attached (Charger Port)

Caution:    DO NOT Short the (+) and the (-) of the Lithium Battery together.