This kit has wires pre-attached to the LEDs, a speaker, a button and a 50mA Rechargeable
battery already. This kit comes completely soldered and ready to be installed. Just drill and glue to your custom vehicle.

For custom sound.   Please send me an email first.

Modes includes:   

                             1. OFF
                             2. Low beam with tail lights
                             3. High beam with tail lights
                             4. High beam with tail lights + Spinner light
                             5. High beam with tail lights + Spinner light + Siren (Old School Crank version)
                             6. Spinner light only (Everything else off)

                             

 

 

Just drill your holes, make your lense and glue the pre-attached LEDs to your chasis.
Drill a hole on the base and glue the push button and the charger connector and you are set.

You can also drill your speaker hole on the base and glue it facing down for clearance.

Note:            Careful not to glue the push button stick.
                     Only apply a dab of glue to the corners initially.

Add head lights and tail lights to your 1:64 car or larger scaled cars. No programming skills needed.
No power toggle switch needed due to battery saving smart Chip design.


Kit includes:

1 x LEDMFUV5SSPIN5 PCB pre-wired to LEDs
2 x WHITE LED (Head Lights) attached
2 x RED LED (Tail Lights) attached
1 x 5 LED (Spinning Light) attached
1 x Button attached
1 x Lithium Battery 50mA attatched
1 x JST 1mm Connector attached (Charger Port)

Caution:    DO NOT Short the (+) and the (-) of the Lithium Battery together.

 

Video: